5 In a matter of seconds, the broadhead extractor will act as an inverse hammer pulling the broadhead out, without bending or breaking it.

6 Once you have the broadhead extracted you can sharpen it by utilizing the disc, as shown in the picture.

1 Unscrew the broadhead from the shaft

2 Clean the area where the broadhead is embedded

3 Fit the disc onto the broadhead extractor

4 Screw the broadhead extractor into the broadhead when the tool is assembled, hold the weight disc between your fingers as shown in the picture, then strike it firmly against the opposite side of the broadhead extractor, repeat as many times as required.